Firmware Upgrade Ask

2 replies [Last post]
chao515
Title: NooBot
Joined: 05/26/2013
Posts:
BotPoints: 9
User offline. Last seen 4 years 23 weeks ago.

I have downloaded firmware from website and copied to USB flash, but I just can enter the recovery mode and the screen shows "insert flash drive", then I changed a flash but it same. The controller is KIPR Link. And the firmware is 1.9.5. What should I do.

Marty Rand
Marty Rand's picture
Title: Botball Youth Advisory Council
Joined: 07/04/2009
Posts:
BotPoints: 253
User offline. Last seen 3 years 17 weeks ago.

Please don't post your question in 2 places. I deleted the other one. If the firmware the Link is already running is 1.9.5, you are on the latest version and you should NOT downgrade due to a fire hazard. Be sure the flash drive is inserted into the Link when you power it on. Also, try both USB ports. Are you able to use a flash drive for program downloading on your Link? If the USB ports are not responding there either, contact KIPR about a defective Link.

-Marty Rand
{
Senior programmer at Norman Advanced Robotics

Former senior programmer at Whittier Middle School

Youth Advisory Council

All around nerd
}

kavita varshney
Title: NooBot
Joined: 11/27/2017
Posts:
BotPoints: 19
User offline. Last seen 2 weeks 3 hours ago.