How would you connect the Create to XBC?

1 reply [Last post]
Title: NooBot
Joined: 11/26/2012
BotPoints: 3
User offline. Last seen 6 years 42 weeks ago.

The name pretty much says it all. Would you you the parallel port or the PS/2 port? Also, where would you connect it?

Jeremy Rand
Jeremy Rand's picture
Title: Botball Youth Advisory Council
Joined: 04/03/2009
BotPoints: 1168
User offline. Last seen 7 years 28 weeks ago.

Hi Hello (your username is awesome!), welcome to the Botball Community!

What version of XBC are you using? If it's an XBCv3 (with the USB port), you should be able to use this cable:

The cable plugs into the round port on the Create, and into the TTL port on the XBC (I believe it's on the left side of the XBC robot board, below the Xport, but I'm not 100% sure on this).

Hope this helps.

-Jeremy Rand
Senior Programmer, Team SNARC (2012-2013), Norman Advanced (2010-2011), Norman HS (2008-2009), Norman North (2005-2007), Whittier MS (2003-2004)
2012-2013 VP of Tech, 2011 President, Botball YAC (2009-2013)
Mentor, Alcott and Whittier MS